Differences

This shows you the differences between two versions of the page.

--- flashing-cmal100 [2020/04/23 04:56] – created ghachey
+++ flashing-cmal100 [2021/02/02 02:10] (current) – external edit 127.0.0.1
@@ Line 7: / Line 7: @@
 You only need to do this if you were given a locked device, typically those locked CMAL100 are for prisons. You may have purchased that one by mistake. It is possible to flash another unlocked firmware that *MUST* be compatible with your device.
-Attached here is a firmware.bin that works with the CMAL100. Download it and following the steps below.
+The firmware.bin will be shared with you by a colleague.
+Plug the network cable in the first LAN port in the CMAL100 and in your main switch as shown below. It should receive an DHCP lease IP address on the "WAN".
+{{ :misc-it:flash-cmal100-1.jpg?nolink |}}
+Enter the username "admin" and password "admin" which is the default.
+{{ :misc-it:flash-cmal100-2.png?nolink |}}
+You should be directed to the following.
+{{ :misc-it:flash-cmal100-3.png?nolink |}}
+Click on ''Backup / Upgrade'' as shown below.
+{{ :misc-it:flash-cmal100-4.png?nolink |}}
+Click on ''Choose file'' and locate your firmware.bin file. Then click ''Ok''.
+{{ :misc-it:flash-cmal100-5.png?nolink |}}
+You should see the following. Wait until the file has completely uploaded.
+{{ :misc-it:flash-cmal100-7.png?nolink |}}
+In my case, I was shown the Authorization Required as below. I removed the password and re-entered the default password and clicked on ''Ok''.
+{{ :misc-it:flash-cmal100-8.png?nolink |}}
+I then fell back to the following with what seemed like nothing changed. I then tried again clicking on the ''Flash image''.
+{{ :misc-it:flash-cmal100-9.png?nolink |}}
+And after the second time this seemed to have worked.
+{{ :misc-it:flash-cmal100-10.png?nolink |}}
-Plug the